Water And Drainage - Oliver Legacy Elite II2017 Owner's Manual

WATER AND DRAINAGE

General Information:
Your new Oliver plumbing system has the dual ability to be self-contained
with on board storage, complimented by a digital holding tank monitoring
system, or to use facilities provided by an external pressurized source. In
either case, the components of the system operate like those in your home.
Components of the plumbing system consist of strong, lightweight,
corrosion resistant materials. By following the instructions outlined here,
you can expect efficient operation with minimum maintenance.
Oliver's plumbing can be divided into two separate systems. The fresh water
system consists of those items, which are used to deliver water for your use,
while the waste water system is made up of the drains, and tanks that store
and remove water that has been used.
Fresh Water System
Fresh water is provided from an external pressurized source or from the
fresh water storage tank. The connection on the Oliver is located at the rear,
bottom driver side corner of the trailer.
External Hookup
Water provided from outside the Oliver is pressurized by the system from
which it is delivered. When you connect your Oliver to an outside source,
the fresh water tank and the water pump are kept separate from the
remainder of the system by in-line check valves.
To attach the Oliver to an outside source of water:
1. Remove the cap from the city water inlet on the side of the Oliver.
2. Attach a potable water hose to the outside source of water.
3. Attach one end of the fresh water hose to the outside source of water.
4. Connect the other end of the hose to the Oliver city water inlet.
5. Turn on the outside source of water. Open the various faucets gradually
to clear the air from the lines. Close the faucets when the water flows
freely.
6. Be sure water heater is full of water before turning on the hot water
heater.
Do not turn the water pump on when using water from an external supply.
67