Making Beds - Oliver Legacy Elite II2017 Owner's Manual

location on the floor. Lower table and line up table leg with base on bottom
of table and support brackets along inner wall. Twist support ring at leg base
1⁄4 turn to lock table leg.
Note: The recess ledge over the rear table is also used for coffee table/end
table when the bed is in use.

Making Beds

Rotate support ring clockwise 1⁄4 turn. Lift table straight up, away from
sidewall support brackets. Remove table leg from base in floor. Remove leg
from base on table. Set table on the back rest cushions to the center and
arrange to make mattress. Store table leg under table on floor or in the
closet.
Repeat procedure above for rear bed and include the extension for bed mode.
LP GAS SYSTEM
READ ALL MANUFACTURER APPLIANCE LITERATURE,
INCLUDING THE INFORMATION ON THE LP BOTTLES AND
REGULATOR, PROVIDED WITHIN THE UNIT PACKET AND
FOLLOW ANY INSTRUCTIONS. – REFER TO MANUFACTURERS
MANUAL. FAILURE TO COMPLY COULD RESULT IN DEATH
OR SERIOUS INJURY.
Filling the LP Gas Tank
Refer to manual
LP Gas Regulator
Refer to manual
LP Gas Detector
Refer to manual
Hoses, Pipes, Tubes and Fittings
The hoses, pipes, tubes and fittings used in your LP system are designed to
withstand pressures far exceeding those of the LP system. However, because
62