Panasonic SDR-H90P Service Manual page 40

SDR-H80P
9.4.3. Set up of PC-EVR Adjustment
Program
1. Turn on the PC and install the PC-EVR Adjustment
Program into the PC.
2. Execute the "khd2009.exe" file by double clicking to start up
the PC-EVR Adjustment Program.
The main menu will be displayed.
3. Select the appropriate model.
4. Turn on the camcorder and set to PC connection (COM)
mode. Then click "Start".
Note:
When the camcorder does not power on, turn the power
on with forced power on function.
<How to turn the power on with forced power on function
>
Push and hold the [MENU] and [JOYSTICK CONTROL
RIGHT], then set [POWER SW] to ON until the power is
turned on.
5. When the communication is complete, the dialog will
appear.
Click "Yes" and "Save" to save the EEPROM data.
6. When EEPROM data has been saved, the menu will
appear.
To perform each adjustment, display the adjustment menu
by selecting from "Camera Adjust" or "Video Adjust" and
select each adjustment item.
Fig. E2-1
Fig. E2-2
Note:
The adjusted data is stored in the EEPROM IC after
each adjustment.
7. After adjustment, to close the software, select "Exit" in the
File menu or close the window.
8. To release the PC connection (COM) mode, push the [OIS],
[iA] and [JOYSTICK CONTROL UP] simultaneously for 3
seconds with the USB Cable disconnected.
9.4.4. How to confirm "OneNAND-Flash
ROM Error"
If there is a problem with Flash ROM (IC3203), the unit does
not turn the power on.
(Problem: When the power SW is turned on, the power LED
lights for 3 seconds and goes out. The power can not be turned
on again.)
If this problem occurs, check if the Flash ROM (IC3203) has a
problem in the following procedure.
1. Start PC-EVR Adjustment Program.
Refer to "9.4.3. Set up of PC-EVR Adjustment Program"
and start PC-EVR Adjustment Program.
40
Fig. E2-3
Fig. E2-4