Using The Trimmer; Brush Cleaning - Panasonic ES4036 Operating Instructions Manual

Using the trimmer

(see fig. 4)
Slide the trimmer handle up to open
the trimmer.
Place the trimmer at a right angle to
your skin and move it downward to
trim sideburns.
Cleaning your shaver
(see fig. 5)
Warning – To prevent electric
shock or personal injury, discon-
nect the power cord from the
shaver and turn the shaver off
before cleaning.
The following is the symbol of Washable
shaver. The symbol means that the
hand-held part may be cleaned under
water.
For cleanliness and convenience, we
recommend that you clean your
shaver with water and a liquid hand
soap. Regular cleaning will keep your
shaver in good condition while pre-
venting odors or bacteria from devel-
oping, and maintain the cutting
performance.
With the outer foil in place, apply
some hand soap onto the outer foil.
Turn the shaver on and pour some
water over the outer foil.
After about 10-20 seconds, turn the
shaver off.
Remove the foil frame and clean it
with running water.
Wipe off any moisture from the
shaver with a dry cloth and remove
the protective cap to allow the outer
foil to dry completely.

Brush cleaning

Squeeze the outer foil release but-
tons and lift the outer foil upward to
remove it. Remove the inner blades
one at a time by grasping it firmly at
both ends and pulling it straight away
from the shaver (see fig. 7). Clean
the outer foils, the shaver body and
the trimmer with the long brush (see
fig. 8). Clean the inner blades with
the short brush by moving it in the
direction in fig. 9(A). Do not use the
short brush to clean the outer foils.
Replacing shaving head
components
It is recommended that you replace
the outer foil at least once a year and
the inner blades at least once every 2
years to maintain your shaver's cut-
ting performance.
Replacing the outer foil
(see fig. 6)
Squeeze the outer foil release buttons
and lift the outer foil upward to
remove it. To insert the new outer foil,
press down until it snaps into place.
Replacing the inner blades
(see fig. 7)
Squeeze the foil frame release but-
tons and lift the foil frame upward to
remove it. Remove the inner blades,
one at a time, by grasping them firmly
at both ends and pulling straight
11
11