Page 1
Fat Shark RC Vision Systems ATTITUDE V4 MODEL FSV1048 USER MANUAL Revision B 05/22/2017 For more product information, please visit: www.fatshark.com All Rights Reserved...
The Attitude V4 has been thoroughly tested with ImmersionRC gear. For best results and no compatibility issues, Fat Shark recommends ImmersionRC gear for your accessory products. IMPORTANT!!!! Product Warning!!!!! DO NOT LEAVE HEADSET EXPOSED TO DIRECT SUNLIGHT.
Fat Shark RC Vision Systems Controls Diagram Channel Selection / DVR Control Display Control Head Tracker Reset Power in RF Module AV in/out IPD adjustment RX on/off DIN Data Port (Head Tracker) Earphone jack Controls Brightness/contrast control: Pressing left/right increases/decreases display contrast.
Fat Shark RC Vision Systems DVR Operation 1. SD card MUST be formatted before use to ensure stable recording. 2. DVR is for analog recording only, no HD recording. 3. Do not place alternative files that you want to keep into the DVR. The DVR may not recognize the file space and write over your files.
For a complete and up to date list of compatible RC radios and their setup, a head tracking sticky thread is maintained at www.FPVlab.com under SPONSORS GATE/FAT SHARK Operation notes: Head tracker initiates in pause mode. Head tracker reset button needs to be depressed and held to start camera motion.
Balancing circuit is already built inside, for charging, only need to connect the barrel connector via the supplied adapter cable to RC charger. Note: this battery can still be charged via the barrel connector with the original Fat Shark headset battery charger.
Fat Shark RC Vision Systems Battery Charging This lithium polymer battery pack is equipped with an internal cell balancing circuit that allows the battery to be charged from standard RC battery chargers. Charge the battery by connecting the barrel connector via the supplied adapter cable and setting the charger for 7.4V, 1000mAh Li-Po, 1A (1C).
This 3 RCA Male to 4-pole Right Angle Cable allows you output the wireless signal from your Fat Shark headset to an external monitor or recording device. It can also be used to connect and display alternative video sources in the goggles.
Fat Shark RC Vision Systems Operational Advice • For best performance, select a channel that has the least amount of interference. While the transmitter is turned OFF, turn on the video headset and look at the screen as you check each channel.
If your problem can’t be solved here, please visit our support forum at www.FPVLAB.com under SPONSORS GATE/ FAT SHARK RC VISION SYSTEMS. Any direct support enquires will be first directed to this forum for the benefit of all customers. Observation...