Output Mixer Block; Effect Block - Panda-Audio Future Impact I User Manual

MIDI CHANNEL (0..16): 0 means OMNI MODE, so all MIDI channels will be
accepted. Otherwise, 1...16 will determine which MIDI channel will FI listen to.
PBD RANGE (0..12): Pitch Bend Range in number of semitones. Determines
how FI will react on modification of the pitch with the pitch bend wheel.
TRANSP OCTAVE (-2..1): The incoming MIDI information can be transposed by
-2, -1, 0 or +1 octaves in order to match the external source to the sounds of FI.
TRIG/GATE (0..1): In GATE MODE (0) a new attack of the sound will be started
only if you release all keys before starting a new one. In TRIGGER MODE (1) a
new attack will be started every time when a key is pressed.
PRIORITY (0..3): This parameter will determine what happens if you play more
than one note at a time. LOWER: Whichever note is the lowest it will be
played. UPPER: Whichever note is the highest it will be played. FIRST:
Whichever not was pressed first it will be played. LAST: Whichever note was
pressed last it will be played.

Output Mixer Block

This is a simple two channel mixer, before the final output to the effect
section.
BASS / VCF (0..127): Setting these will determine the loudness ratio between
the direct bass sound and the sound coming from the synthesizer / harmonizer
through the VCF.

Effect Block

The effect block contains three effects at the time of the product release, and
it will be enhanced further later.
TYPE (0..3): The effect type can be selected here. The choices are: BYPASS (0),
CHORUS / FLANGER / SLAPBACK / REVERB (1), OVERDRIVE (2), EQUALIZER (3).
The parameters of the different effects will be discussed separately.
BASS/VCF (0..127) or (0..1): With these controls you can determine which of
the two main signals (BASS and VCF) will be routed through the effect section.
This is slightly different for effect type 1 and 2 or 3. For the time modulation
effect you can determine on a 0..127 continuous scale the blend ratio between
the dry and the effected signal. In case of Overdrive or Equalizer such a blend
control makes no sense, so the controller is either 0 for dry only or 1 for effect
only.
Page | 9