Panasonic NA-F100A1 Operating & Installation Instructions Manual page 13

■ Make sure to ask a service person for installation. Do not install by yourself.
■ If the installation, test run and inspection of the washing machine are not carried out following this installation
method, Panasonic will not be liable for any accident or damage caused.
4. Connect the water tap adaptor and water supply hose.
Water faucet
Water tap adaptor
Water supply hose
CAUTION
● Tighten the nut firmly.
● Do not twist, squash, modify
or cut the hose.
5. Connect the power plug and grounding wire.
● Ask a service person to do the grounding work.
● In case of a 2-pin power cord, establish a ground.
6. Check that the washing machine is level.
■
Check the balance state using a plummet:
1
Take upper edge of the body as the base. From this
position, release the string to make it vertical to the ground.
2
Take lower edge of the body as the base. Measure the
distance from the edge to the string. The distance must
be less than 10 mm to the left, to the right, to the front,
and to the back of the machine.
String
Less than 10 mm
Plummet
7. Perform a trial operation.
● Check that there is no water leakage, abnormal sounds or error display.
1
Connect the water tap
adaptor to the water faucet.
1
Turn part A to the left until approx.
4 mm of the thread becomes visible.
2
Loosen the 4 screws.
3
Connect to the faucet and tighten
the screws.
4
Turn part A to the right and tighten
securely. (To prevent water leakage)
2
Connect the water
supply hose to the water
tap adaptor.
Insert the hose into the adaptor while
pushing down the lever, and hook
the claw of the lever on the flange of
the adaptor.
3
Connect the water
supply hose to the water
supply valve screw.
1
Hold the elbow and tighten the nut.
2
Check that the elbow is not loose.
Upper
edge
Body
Lower
edge
Screw
Thread
Claw
Lever
Elbow
■
If the washing machine wobbles
1
Turn the adjustable leg
knob to the left to loosen.
2
Turn the
adjustable leg
to eliminate
wobble.
To raise
Part A
Flange
Nut
Water supply
valve screw
Water supply hose
3
Turn to
the right to
tighten.
To lower
13