Advertisement

Quick Links

SERVICE MANUAL
Ver 1.1 2003.05
Sony Corporation
9-877-075-02
Personal Audio Company
2003E02-1
Pubulished by Sony Engineering Corporation
© 2003.05
SPECIFICATIONS
Speaker section
Enclosure type
Full range, Bass reflex,
magnetically shielded
Speaker system
39 mm (diameter)
Impedance
8 Ω
Rated input power
3 W
Amplifier section (Left Speaker)
Rated output
3 W + 3 W (10 % T.H.D., 1 kHz, 6 Ω)
Bass boost
MEGA BASS
Input Input cord a stereo-mini plug (2 m) x 1
Stereo mini jack x 1
Input impedance
4.7 kΩ (at 1 kHz)
Output
Stereo mini jack x 1 (PHONES)
General
Power
DC 9V (supplied AC power adaptor)
Dimensions (w/h/d)
approx. 50 x 145 x 70 mm
(2 x 5
Mass
(Left) 250 g (9 oz.),(Right) 200 g (7 oz.)
Supplied accessories
AC power adaptor (1)
Operating Instructions (1)
Design and specifications are subject to change without notice.
SRS-Z30
3
7
/
x 2
/
inch)
4
8
ACTIVE SPEAKER SYSTEM
US Model
Canadian Model
AEP Model
UK Model
E Model
Australian Model
Tourist Model

Advertisement

Table of Contents
loading

Summary of Contents for Sony SRS-Z30

  • Page 1 (Left) 250 g (9 oz.),(Right) 200 g (7 oz.) Supplied accessories AC power adaptor (1) Operating Instructions (1) Design and specifications are subject to change without notice. ACTIVE SPEAKER SYSTEM Sony Corporation 9-877-075-02 Personal Audio Company 2003E02-1 Pubulished by Sony Engineering Corporation © 2003.05...
  • Page 2: Table Of Contents

    REPLACE THESE COMPONENTS WITH SONY PARTS WHOSE FONCTIONNEMENT. NE REMPLACER CES COMPOSANTS PART NUMBERS APPEAR AS SHOWN IN THIS MANUAL OR IN QUE PAR DES PIÈSES SONY DONT LES NUMÉROS SONT SUPPLEMENTS PUBLISHED BY SONY. DONNÉS DANS CE MANUEL OU DANS LES SUPPÉMENTS PUBLIÉS PAR SONY.
  • Page 3: Diagrams

    SRS-Z30 SECTION 2 DIAGRAMS 2-1. SCHEMATIC DIAGRAM • Refer to page 6 for Notes.
  • Page 4: Printed Wiring Boards (1/2)

    SRS-Z30 2-2. PRINTED WIRING BOARDS (1/2) • Refer to page 6 for Notes. : USES UNLEADED SOLDER. SPEAKER AMP BOARD (SIDE A) (12) 1-685-794- • Semiconductor Ref. No. Location...
  • Page 5: Printed Wiring Boards (2/2)

    SRS-Z30 2-3. PRINTED WIRING BOARDS (2/2) • Refer to page 6 for Notes. : USES UNLEADED SOLDER. DC IN 9V R OUT INPUT 2 AMP BOARD (SIDE B) (INPUT 1) VOLUME (12) 1-685-794-...
  • Page 6 SRS-Z30 For schematic diagrams. • IC BLOCK DIAGRAM Note: • All capacitors are in µF unless otherwise noted. pF: µµF 50 WV or LM358D IC2,3 TEA2025D-013TR less are not indicated except for electrolytics and tantalums. • All resistors are in Ω and W or less unless otherwise specifed.
  • Page 7: Exploded Views

    SRS-Z30 SECTION 3 EXPLODED VIEWS NOTE : • Hardware (# mark) list and accessories and • -XX, -X mean standardized parts, so they packing materials are given in the last of this may have some difference from the original parts list.
  • Page 8: Electrical Parts List

    SRS-Z30 Ver 1.1 2003.05 SECTION 4 ELECTRICAL PARTS LIST NOTE : • Due to standardization, replacements in the • SEMICONDUCTORS The components identified by parts list may be different from the parts In each case, u : µ , for example :...
  • Page 9 SRS-Z30 Ver 1.1 2003.05 Ref. No. Part No. Description Remark 1-216-834-11 METAL CHIP 1/10W 1-218-667-11 METAL CHIP 1/10W 1-216-829-11 METAL CHIP 4.7K 1/10W 1-216-829-11 METAL CHIP 4.7K 1/10W 1-216-813-11 METAL CHIP 1/10W 1-216-833-11 METAL CHIP 1/10W 1-216-813-11 METAL CHIP 1/10W 1-216-827-11 METAL CHIP 3.3K...
  • Page 10: Revision History

    SRS-Z30 REVISION HISTORY Clicking the version allows you to jump to the revised page. Also, clicking the version at the upper right on the revised page allows you to jump to the next revised page. Ver. Date Description of Revision 2003.02...

Table of Contents