Audi TT Repair Manual page 166

Audi TT 2007 ➤
Heating, Ventilation and Air Conditioning - Edition 01.2011
Note
The following describes removal and installation on a 2.5L
♦
TFSI vehicle. The procedure may be different on 5 cylinder
vehicles.
5 cylinder vehicles have a condenser -A- that has an additional
♦
double pipe -C- bolted on to the condenser -A-. The double
pipe -C- is currently not supplied with the condenser. Refer to
the Electronic Parts Catalog. To loosen or screw the double
pipe -C- on to the condenser -A-, use the same tightening
specification for the screws on the connections as for the
screws on the refrigerant lines -D- and -E-.
Removing
– Switch off ignition.
Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
– Discharge refrigerant circuit. Refer to ⇒ Refrigerant R134a with respect to the correctness of information in this document. Copyright by AUDI AG.
Servicing; Rep. Gr. 00 ; Description and Operation (A/C Serv‐
ice Station).
– Remove the air intake leading to the air filter housing. Refer to
⇒ Injection and Ignition System; Rep. Gr. 24 ; Removal and
Installation .
– Remove fan shroud. Refer to⇒ Engine Mechanical; Rep. Gr.
19 ; Removal and Installation .
– Disconnect refrigerant lines from condenser. Refer to
⇒ "5.18.12 Refrigerant Lines, Disconnecting and Connecting
from Condenser", page 178
– Remove the front bumper cover. Refer to ⇒ Body Exterior;
Rep. Gr. 63 ; Removal and Installation .
– Remove bolts -arrows- by releasing air ducts at left and right
and tipping in direction of head lamps.
– Tip top edge of cooler back slightly. Refer to⇒ Engine Me‐
chanical; Rep. Gr. 21 ; Removal and Installation .
– Disengage cooler from lower mounting points by raising it.
– Slide cooler in direction of engine.
– Support cooler from below so that it cannot sink.
162
Rep. Gr.87 - Air Conditioning
.