Table of Contents
Advertisement
CUTTING & INSTALLING THE REAR BRACKET
IMPORTANT:
Optimal installations occur when the values of "A" and "B" are as close to each other as possible.*
If necessary, cut the rear bracket then weld the bracket to the post as shown in Fig 5.
ATTACHING THE FRONT BRACKET
SECURING THE GEAR MOTOR AND REAR BRACKET
3
Open the
release door and
remove the 2 screws
that secure the rear
cover as shown in Fig. 7a. Next, remove the top
cover by sliding it slightly backwards.
The front bracket must be fixed to the door accord-
ing to the dimension "C" in Fig 4. The front bracket
must be fixed at the same height as the rear bracket
as shown in Fig 6.
Fig. 7
a
1
2
2
2
1
Place the gear motor against the bracket and insert
the fixing screw as shown in Fig. 7b.
5
Fig. 5
The fixing position
of the rear bracket
is determined
according to the
graphic and mea-
surement table
listed in Fig 4.
Fig. 6
b
Advertisement
Table of Contents
