Table of Contents
Advertisement
(STEP 3 continued)
Safety device connected
during programming?
=no
=yes
Press either:
if you DO NOT intend safety devices to be enabled during programming
if you DO intend safety devices to be enabled during programming
STEP 4:
Continue through COMPLETE auto-learning of gate and configure deceleration points by taking the
following steps:
UNLOCK MOTOR (S)
Position in the middle of
travel stroke path
unlock motor (s)...
= OK
Press
to begin
learning OPEN limit
NOTE: M1 must always open before M2. If the motors are inverted, stop the procedure
in the control unit by pressing
two motors and start again from the beginning.
SINGLE LEAF CONFIGURATION
closing m
...
1
= Slow down start
Press
to set the M1
deceleration point on
the closing direction
NOTE: If there are safety devices connected, during travel stroke programming,
the safety devices can be deactivated to prevent accidental interruption of this
operation. At the end of the autolearning procedure, the safety devices selected
earlier will be reactivated.
Unlock motor(s) with
Key on Transmitter
opening m
...
1
reverses direction
Press
or
to
reverse direction of M1
if gate is not traveling in
the OPEN direction
on the display, swap the power supply terminals of the
Learning...
closing m
...
1
Closing limit of the M1
will be automatically
learned
Manually position gate(s)
in middle of travel stroke
path
learning...
opening...
Indicates learning
opening direction of M1
(For double leaf configuration, see next page)
Learning...
closing completed
20
Lock motor(s) back in
place with Key on
Transmitter
opening complete
double leaf?
Press either:
if configuring single leaf
(see below)
if configuring double leaf
(see next page)
opening m
...
1
= Slow down start
Press
to set the M1
deceleration point on
the closing direction
Advertisement
Table of Contents
