Service And Replacement Guide - Toastmaster XO-1N Owner's Manual

SERVICE AND REPLACEMENT GUIDE

SERVICE AND REPLACEMENT GUIDE
Your TOASTMASTER
fact, any individual with average mechanical ability can do the work. Call
®
TOASTMASTER at (906) 863-4401 and ask for our Service Department to order
replacement parts, ask questions, or offer comments.
Our Service Department is available to you Monday through Friday from 7:00 a.m. to 5:00
p.m. (CST) should you find yourself with a situation or problem other than we have
outlined. Our technicians are also available via pager from 7:00 a.m. to 10:00 p.m. during
week-ends and holidays.
This SERVICE AND REPLACEMENT GUIDE has been prepared to cover most normal
service problems. If this "trouble–shooting" information does not provide a solution for
your particular problem we ask that you call us for direct assistance. Calling our Service
Department before calling in a repair technician can usually save you both time and
unnecessary expense. We want to do everything we can to minimize your "down-time".
You may need to remove an access panel for servicing. DO NOT allow any access panels
to drop. When work on the component is finished replace the panel with care, making sure
that all wires are properly placed and not pulled or pinched. If more than one component is
being worked on try to remove only one component at a time.
TEMPERATURE CONTROL, How to Adjust:
A. Place a reliable thermometer (or the thermocouple of a test instrument) on a pan in
the center of the Oven. Turn the unit ON and set the Temperature Control [14] to
its normal setting. Allow the equipment to reach a stable operating temperature.
B. Compare the Temperature Control setting to the reading on the test instrument
when the Temperature Control Indicator Light [16] goes out. If there is a
difference of more than 25 you may need to recalibrate the Temperature Control.
Please call the NU-VU
calibration procedures before attempting to re-calibrate the Oven!!!
C. If the difference is less than 25 a simple dial adjustment may solve the problem:
1. Loosen the Knob of the Temperature Control by loosening the two set screws
on the sides of the knob.
2. With the screws loosened, turn the knob so the white mark is aligned with the
temperature reading from the test instrument.
3. Tighten the set screw on the sides of the knob.
4. Check the control setting against the test instrument and repeat this procedure
if necessary.
D. If this procedure fails to bring the temperature reading within the desired specs,
please call the TOASTMASTER
on calibrating the thermostat itself.
NU–VU FOOD SERVICE SYSTEMS
page 10
®
XO–1N has been designed to be serviced quickly and easily. In
®
Service Department at (906) 863-4401 for the proper
®
Service Department for advanced instructions
SALES FAX (906) 863-5889 • SERVICE FAX (906) 863-6322
XO–1N OWNER'S MANUAL
MENOMINEE, MICHIGAN 49858
(906) 863-4401