Sony LSPX-P1 Reference Manual page 9

malfunction. Although the projection
window is made of tempered glass, if it is
strongly pushed or struck, it may break
causing injuries.
• Take care not to drop the unit when
moving it. If the unit falls, it may break or
cause injuries.
On placement
• Do not place the unit in any places where
there is excessive dust or cigarette smoke.
Dust and cigarette tar adheres to
components inside the unit (such as the
projection window) causing a
malfunction.
• Do not place the unit in any places where
the temperature is extremely hot or cold,
or the humidity is extremely high.
Especially when there is strong sunshine
or during the summer, the inside of a car
can get quite hot, and a unit left in the car
may deform or malfunction.
• Do not place the unit on an unstable
surface. The unit may fall or topple over
resulting in injuries.
• Do not place the unit where there is
water. It may cause a fire or electric shock.
• Do not place/store the unit in a place
exposed to direct sunlight or close to a
heater. Heat may build up in the unit
causing a fire.
On AC adaptor and cables
• Do not damage the power cord. It may
cause a fire or electric shock.
• Be sure to use the supplied AC adaptor
with the unit. If a different AC adaptor is
used with the unit, it may cause a fire,
electric shock or malfunction.
• Do not touch the power plug with wet
hands. It may cause an electric shock.
• Before making connections with the AC
adaptor and connection cables, turn off
the unit and connected equipment, and
unplug the power plugs from the wall
outlet.
• Do not wrap the power cord or
connection cable around the AC adaptor.
It may cause the cord or cable to break.
• Before moving the unit, disconnect the
power cord and connection cables. The
cables may be damaged resulting in a fire
or electric shock, or connected equipment
may fall or topple over causing injuries.
• Insert the connector straight. If it is
inserted at an angle, pins may make a
short circuit causing a fire.
On fan noise
A fan is incorporated inside the projector to
prevent overheating, and this makes a
slight noise while turned on. This noise is
9
GB