Schematic Diagrams - Samsung DVD-P360/CDM Service Manual

11. Schematic Diagrams

11-1 S.M.P.S (Jack PCB) - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - -
11-2 Front Micom (Jack PCB) - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - -
11-3 Audio (DVD Main PCB) - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - -
11-4 AV Decoder (DVD Main PCB)- - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - -
11-5 RF-Servo (DVD Main PCB)- - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - -
11-6 Video (DVD Main PCB) - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - -
11-7 Power Key (Power Key PCB) - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - -
Samsung Electronics
11-2
For schematic Diagram
- Resistors are in ohms, 1/8W unless otherwise noted.
11-3
Special note :
Most semiconductor devices are electrostatically sensitive and therefore require the special handling techniques described under the
11-4
"electrostatically sensitive (ES) devices" section of this service manual.
11-5 Note :
Do not use the part number shown on this drawing for ordering. The correct part number is shown in the parts list (may be slightly
different or amended since this drawing was prepared).
11-6
Important safety notices :
11-7
Components identified with the mark
Use only the same type.
11-8
◆ Block Identification of Main PCB
AV OUT
ENCODER
DECODER
This Document can not be used without Samsung's authorization.
Note
have the special characteristics for safety. When replacing any of these components.
SERVO
POWER KEY
FRONT MICOM BLOCK
SMPS
BLOCK
11-1