City Water Connections - Tiffin Motorhomes WAYFARER 2017 Owner's Manual

SITUATION
Pump running – no water
Pump doesn't Run
All the water should be drained from the freshwater system when the unit is not in use for extended
periods. For more detailed information regarding the water pump, one should refer to the water-pump
manufactures brochure.

CITY WATER CONNECTIONS

When connecting your unit to city water, use the water hose
manufactured and labeled for potable water service—this will assure
that the hose selected for use will not alter the taste of the water
(Figure 13-6).
To connect the city water supply, connect one end of the hose to the city water supply.
Turn the city water supply "on" for a few seconds to clear the line. Once the hose has been flushed, turn
the supply "off." Connect the other end of the hose to the inlet valve on the sewer board; turn the blue
handle valve on the sewer board to the city water fixtures turn the red handle valve on the sewer board
to normal. ( Note: As the water goes through the inlet and then passes
all water exiting the faucets and showers have been filtered).
water is supplied to the freshwater system including the hot water heater, faucets, and toilet. Turn "on"
the water supply and open all of the faucets to clear any trapped air within the plumbing lines within the
motor home.
Once any air pockets have purged from the water lines and water flows freely, close all the faucets. The
city water supply is pressurized; therefore, the water pump is not needed when the water system of the
vehicle is connected to the city water system.
PLUMBING & BATH FEATURES
SOLUTION
1. Fill tank
2. Clear the water line to the pump
1. Check the pump switch.
2. Check the 12-volt fuses
3. Check the electrical connections
4. Check the Battery
81
Figure 13-6: City Water Hookup
through the filter insuring that
Once the city water fill valve is opened,