Installing Batteries; Operation - Cobra AM845 Manual

Installing Batteries

To install or replace batteries:
Remove Belt Clip
Pull Up Lock Latch
Insert Batteries
Radio Charger Jack
Use only the supplied rechargeable batteries and charger for recharging
your Cobra microTALK radio.
Cobra recommends your radio is turned off while being charged.
Non-rechargeable alkaline batteries can also be used in your radio.
Maximum/Minimum Operating Range: -20°C to +45°C.
Maximum SAR values: 0.934W/kg for FM 25KHz (boby-Worn).
English
1. Remove belt clip by releasing belt clip
latch and sliding clip up.
2. Pull up on the battery door latch to remove the battery
compartment cover.
3. Insert the supplied three AA rechargeable batteries or non-
rechargeable alkaline batteries. Position batteries according
to polarity markings.
4. Replace battery compartment cover and
belt clip.
• Do not attempt to charge alkaline batteries.
• Do not mix old and new batteries.
• Do not mix alkaline, standard (carbon-zinc), or
rechargeable (Ni-Cd, Ni-MH, etc.) batteries.
Caution - Risk of fire or explosion if battery is replaced by an
incorrrect type. Dispose of used batteries
according to the instructions.
To charge batteries in radio:
1. Check to see that the batteries have been inserted properly.
2. Insert the cable into the charge jack located at the top of
the radio.
3. Plug the cable into USB-compatible power source.
Nothing Comes Close to a Cobra

Operation

•
3
®