Philips BDP3010/F8 Service Manual page 48

AV CBA Bottom View
CAUTION !
Fixed voltage (or Auto voltage selectable) power supply circuit is used in this unit.
If Main Fuse (F1001) is blown , check to see that all components in the power supply
circuit are not defective before you connect the AC plug to the AC power supply.
Otherwise it may cause some components in the power supply circuit to fail.
WF1 WF2
WF6 WF4
PIN 9 OF
PIN 7 OF
CN2200
CN2200
WF3
C2303
PLUS LEAD
1-10-19
WF4 WF5
WF8
PIN 16 OF PIN 24 OF
CN2200 CN2200
A
CAUTION !
F
For continued protection against fire hazard,
replace only with the same type fuse.
V
ATTENTION : Pour une protection continue les risqes
d'Incele n'utiliser que des fusible de même type.
Risk of fire-replace fuse as marked.
"This symbol means fast operating fuse."
"Ce symbole reprèsente un fusible à fusion rapide."
NOTE:
The voltage for parts in hot circuit is measured using
hot GND as a common terminal.
Because a hot chassis ground is present in the power
supply circut, an isolation transformer must be used.
Also, in order to have the ability to increase the input
slowly, when troubleshooting this type power supply
circuit, a variable isolation transformer is required.
BE5P00F01012-A