Configuring The Maximum Hops Of An Mst Region; Configuring The Network Diameter Of A Switched Network - H3C S5830V2 series Configuration Manual

To configure the priority of a device in a specified MSTI:
Step
1. Enter system view.
2. Configure the priority of
the current device.

Configuring the maximum hops of an MST region

Restrict the region size by setting the maximum hops of an MST region. The hop limit configured on the
regional root bridge is used as the hop limit for the MST region.
Configuration BPDUs sent by the regional root bridge always have a hop count set to the maximum value.
When a device receives this configuration BPDU, it decrements the hop count by one, and uses the new
hop count in the BPDUs that it propagates. When the hop count of a BPDU reaches zero, it is discarded
by the device that received it. Devices beyond the reach of the maximum hops can no longer participate
in spanning tree calculations, so the size of the MST region is limited.
Make this configuration only on the root bridge. All other devices in the MST region use the maximum
hop value set for the root bridge.
You can configure the maximum hops of an MST region based on the STP network size. H3C
recommends that you configure the maximum hops to a value that is greater than the maximum hops of
each edge device to the root bridge.
To configure the maximum number of hops of an MST region:
Step
1. Enter system view.
2. Configure the maximum hops
of the MST region.
Configuring the network diameter of a switched
network
Any two terminal devices in a switched network can reach each other through a specific path, and there
are a series of devices on the path. The switched network diameter is the maximum number of devices on
the path for an edge device to reach another one in the switched network through the root bridge. The
network diameter indicates the network size. The bigger the diameter, the larger the network size.
Based on the network diameter you configured, the system automatically sets an optimal hello time,
forward delay, and max age for the device.
In STP, RSTP, or MSTP mode:
Command
system-view
•
In STP/RSTP mode:
stp priority priority
•
In PVST mode:
stp vlan vlan-id-list priority priority
•
In MSTP mode:
stp [ instance instance-list ] priority
priority
Command
system-view
stp max-hops hops
100
Remarks
N/A
The default setting is 32768.
Remarks
N/A
The default setting is 20.