LP6-S-L Pendant Mount Satellite Table of Contents | en Speaker Table of contents Safety Introduction System overview Packing list Product information Dimensions Pendant suspension cable Wiring Installation Troubleshooting Technical data Frequency response and impedance Bosch Security Systems B.V. Installation Manual...
The user is responsible for making sure the wall, ceiling, or structure is capable of supporting all objects suspended overhead. Any hardware used to suspend a loudspeaker not associated with Bosch is the responsibility of others.
Speaker Introduction The LP6-S-L Pendant Mount Satellite Speaker is a companion speaker option to the Compact Sound Speaker System offering from Bosch . It provides a convenient way to equip open ceiling spaces with sound where conventional surface or ceiling mount speakers cannot be used.
LP6-S-L Pendant Mount Satellite en | System overview Speaker System overview Packing list The major components included in one (1) box for the LP6-S-L pendant speaker system. Item Quantity Description Pendant speakers Pendant suspension cables Couplers Wire cap screws Installation manual Product information 2015.10 | 02 |...
Speaker Pendant suspension cable The pendant suspension cable is supplied with the LP6-S-L kit. The material is strong steel wire rope. It is designed with a locking spring mechanism which secures the wire rope and allows for easy adjustment of the installation height, up to 15 ft (4.57 m).
LP6-S-L Pendant Mount Satellite Wiring | en Speaker Wiring Wiring the pendant speaker is recommended before installation. Carefully observe the wire markings or tracers on your speaker wires. Verify the amplifier (+) terminal is connected to the red speaker terminals and the amplifier (-) terminal is connected to the black speaker terminals.
LP6-S-L Pendant Mount Satellite en | Installation Speaker Installation Wiring the pendant is recommended before installation. For more information, see Wiring, page 9. To install the pendant speaker, do the following: Thread the cable into the coupler. Adjust the pendant suspension cable length.
Page 11
LP6-S-L Pendant Mount Satellite Installation | en Speaker Once the proper height adjustment has been made, put the cable tail through the through hole of the coupler, and leave at least 10 cm (4 in) of length. Tighten the screw to secure the cable.
LP6-S-L Pendant Mount Satellite en | Troubleshooting Speaker Troubleshooting Problem Possible Causes Action No Sound Amplifier Connect a known working test speaker to the amplifier outputs. If there is no sound, check all electronics are on, the signal routing is correct, the source is active;...
LP6-S-L Pendant Mount Satellite Technical data | en Speaker Technical data LP6-S-L Freq. Response (-10 dB): 150 Hz - 20 kHz Power Handling: 30 W Sensitivity: 84 dB Impedance: 16 Ohms Maximum SPL: 102 dB Voice Coverage (H x V): 150° x 150°...
LP6-S-L Pendant Mount Satellite en | Technical data Speaker Frequency response and impedance 95.00000 85.00000 75.00000 65.00000 Frequency, Full Space Impedance 55.00000 3.16 1000 10000 20000 Frequency (Hz) 2015.10 | 02 | Installation Manual Bosch Security Systems B.V.