Table of Contents
Advertisement
Chapter 4
Note:
It may take 1-2 minutes to make the settings valid.
Tips:
• If your internet connection type is
• If you use
Dynamic IP
and
please go to
Advanced
>
• If you still cannot access the internet, refer to the
4. 3.
Set Up an IPv6 Internet Connection
Your ISP provides information about one of the following IPv6 internet connection types:
PPPoE, Dynamic IP(SLAAC/DHCPv6), Static IP, 6to4 tunnel, Pass-Through (Bridge).
1. Visit http://tplinkwifi.net, and log in with your TP-Link ID or the password you set for
the router.
2. Go to
Advanced
> IPv6.
3. Enable IPv6 and select the internet connection type provided by your ISP.
Tips:
If you do not know what your internet connection type is, contact your ISP or judge according to the already known
information provided by your ISP.
4. Fill in information as required by different connection types. Red blanks must be filled
in.
1 )
Static IP:
Fill in blanks and click Save.
BigPond
Cable, please go to
PPPoE
and you are provided with any other parameters that are not required on the page,
Network
>
Internet
to complete the configuration.
FAQ
Advanced
>
Network
section for further instructions.
Set Up Internet Connection
>
Internet
to set your router.
17
Hide quick links:
Advertisement
Table of Contents
