Switching Off The Device - Hama BASIC L42A Operating Instructions Manual

G
4.3 Lamination
■ Place the document to be laminated in the appropriate pouch (see
figure).
■ Insert the film pouch into the front opening of the device (4). Make
sure that the sealed end is inserted first.
nOtE
►
‹ The document is returned at the rear (5).
‹ If an item has not been fully laminated, repeat the first steps.
CaUtIOn!
►
nOtE
►

4.4 Switching off the device

‹ Press the on/off switch
lamp
6
Film pouches of all sizes should be inserted at the centre of
the front opening so that they pass through the sensor.
Laminated items coming out of the device may be too hot to
touch.
The laminated sheet is hot and can be bent easily. Place the
item on a flat surface and leave to cool so that it does not
curl at the edges.
2
goes out.
3
to switch off the device. The ready
Basic L42A