Installing And Configuring The Host; Loading The Operating System And Software; Installing And Configuring The Hbas; Clustering And Fabric Zoning - HP StorageWorks XP24000 Configuration Manual

Figure 3 Simple point-to-point fabric topology example
Table 2 Fabric topology settings
Fabric parameter
ON
OFF
ON
OFF

Installing and configuring the host

This section explains how to install and configure the host and host bus adapters (HBAs) that connect
the host to the disk array.

Loading the operating system and software

Follow the manufacturer's instructions to load the operating system and software onto the host. Load
all OS patches and configuration utilities supported by HP and the HBA manufacturer.

Installing and configuring the HBAs

Install and configure the host bus adapters using the HBA manufacturer's instructions.

Clustering and fabric zoning

NOTE:
The following discussion of clustering applies when the Windows Guest OS is clustered using Microsoft
Cluster Service (MSCS).
If you plan to use clustering, install and configure the clustering software on the servers.
Clustering is the organization of multiple servers into groups. Within a cluster, each server is a node.
Multiple clusters compose a multi-cluster environment. The following example shows a multi-cluster
environment with three clusters, each containing two nodes. The nodes share access to the disk array.
16 Installing and configuring VMware for the XP disk array
Connection parameter
FC-AL
FC-AL
Point-to-Point
Point-to-Point
Provides
Not supported
Not supported
N-port (SAN fabric port)
Not supported