C.L.BECKER HHPC 170/21 Operating And Maintenance Instructions Manual page 8

60hz
Table of Contents

Advertisement

The operation of oil-heated high pressure cleaners in enclosed spaces is prohibited
without aeration and proper exhaust system! Exhaust gases are harmful to health, in-
creased concentrations of carbon monoxide can be deadly!
The operation of by combustion engines driven high pressure cleaners in enclosed
spaces is prohibited without aeration and proper exhaust system! Exhaust gases are
harmful to health, increased concentrations of carbon monoxide can be deadly!
Inadequate and faulty high-pressure hoses are often a cause of accidents in the oper-
ation of high pressure cleaners. Be sure to check the hoses before each start-up for
external damage. Replace damaged high pressure hoses in principle immediately
against HANSEAT original high-pressure hoses. If you use other high-pressure hoses
than the original delivered by C. L. Becker GmbH the liability expires. Product liability
and warranty claims are voided.
Used, damaged high pressure hoses must not be repaired or used again after DIN EN
982/5.3.4.3. Replace them with original HANSEAT high pressure hoses.
High-pressure cleaners must not be put up in fire-threatened and explosion-
threatened rooms.
When dealing with fuels use the necessary care. Observe safety rules and technical
hazards, and environmental regulations.
Please also note that the resulting effluent during the washing process can be made
environmentally acceptable, e.g. via an oil separator, from the extraction system, the
collection, filtering and disposal of contaminated water.
Electricity can cause serious injuries! Remove all references to faulty electrical
equipment seriously and eliminate possible causes for accidents immediately. Let the
troubleshooting run exclusively by professionals. Unplug the unit for all repair and
maintenance work from the power. Do not take the device in operation when power
cord, plugs, switches, etc. are defective.
The area of the exhaust system gets very hot! You can get burned - do not touch!
Make sure before starting that hoses, guns and other accessories are suitable for the
required operating pressures and operating temperatures.
The pressure washer must be operated in a vertical position standing on a horizontal
flat surface and is set up that it is absolutely safe and secured against rolling away
and slipping.
Let not the unit run longer than 3 minutes if the gun is closed. If it runs long time, the temperature of
the circulating water rises to fast. This can damage the pump.
Be careful when using hard water to a sufficient decalcification.
BA HHPC-170/21 60Hz englisch
Art.Nr. 02505004/60/BECKER/ENG
Stand 05/2013
Seite 8 von 23

Hide quick links:

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the HHPC 170/21 and is the answer not in the manual?

Table of Contents

Save PDF