Advertisement
Kambrook Recommends Safety First
IMPORTANT: Please retain your
instruction book for future use.
At Kambrook, we believe that safe performance is the first priority in any
consumer product, so that you, our valued customer can confidently
use and trust our products. We ask that any electrical appliance that
you use be operated in a sensible fashion with due care and attention
placed on the following important operating instructions.
Important Safeguards For Your Kambrook
Radiant Heater
• Keep combustible materials such as curtains/
drapes and other furnishing away from heater.
• The heater must NOT be located immediately
below a socket outlet.
• Extreme caution is necessary when
this heater is used by or near children
or invalids.
• Young children should be supervised to ensure
they do not play with the heater.
• Important – this heater is intended for floor use
only. Do not mount on ceiling or walls.
• Do not leave heater unattended. Always
switch off the heater at the controls and at
the power outlet then unplug heater from the
power outlet when not in use.
• Do not operate any heater with a damaged
cord or plug, or if heater has been dropped
or damaged in any manner. Return heater to
your nearest service centre for examination,
electrical or mechanical adjustment or repair.
• Do not use outdoors.
• This heater is not intended for use in wet or
moist locations such as bathrooms or laundry
areas. DO NOT IMMERSE or allow liquids to be
spilt on heater.
• Do not cover the heater.
• Place unit well clear of heat sensitive surfaces
and where necessary place on a suitable
stable inflammable surface.
4
• Do not run the cord under carpeting or cover
the cord with rugs, runners or the like. Arrange
cord away from traffic areas and where it will
not be tripped over.
• To prevent a possible fire, allow ample space
around the heater (at least 1.7m at front and
0.5m at the rear, top and sides) and do not
block air inlets or outlets in any manner. Check
the elements and grill from time to time for
accumulated dust.
• To disconnect heater switch the control setting
to the OFF position, then switch off at the
power outlet prior to removing the plug from
its outlet.
• Do not insert or allow foreign objects to pass
through the element guard as this may cause
an electric shock, fire or damage the heater.
• Do not touch hot metal surfaces.
• Do not allow power cord to contact hot metal
surfaces.
• Set the control setting to the OFF position then
unplug and allow heater to cool down before
cleaning or storing.
• The heater will not operate unless it is placed
on a flat level surface as it is fitted with a tilt
switch.
• Do not use the heater with a programmer,
timer or any other device that switches
the heater on automatically.
Advertisement
