DigiTech DC-1074 Instruction Manual page 8

and melody number will blink on the LCD display.
2. Press the
CH UP or CH DOWN buttons to set the desired
melody, between the 5 available melodies.
3. To confirm the selection and exit the Menu mode, press
LOCK button or MENU button to move to the next function.
4. Press the Call button to transmit the Call Tone Melody.
Roger Beep Tone Setting
The radio is equipped with a user selectable Roger Beep Tone
feature, which enables you to send a Beep Tone at the end of
each transmission after every release of the PTT button.
This will prompt any receiving unit that your transmission has
ended. To enable or disable this function, please proceed as
follows:
1. Press the MENU button nine times, until the Roger Beep icon
and the On or OFF indications will blink on the LCD display.
2. Press the CH UP or CH DOWN buttons to set the desired
selection On (Roger Beep tone enabled) or OFF (Roger Beep
tone disabled). If the Roger Beep function is enabled, a beep
tone is heard to confirm the selection.
3. To confirm the selection and exit the Menu mode, press
LOCK button or MENU button to move to the next function.
4. When the Roger Beep tone is enabled, the tone icon appears
on the LCD display.
Keypad Program Tone Setting
When a key is pressed, a beep tone is heard to confirm your
command. The user may enable or disable this keypad program
tone.
1. Press the MENU ten times, until the keypad tone icon and the
On and OFF indications will blink on the LCD display.
2. Press the CH UP or CH DOWN buttons to set the desired
selection on (keypad tone enabled) or OFF (keypad tone
disabled). If the keypad tone is enabled, a beep tone is heard to
confirm the selection.
3. To confirm the selection and exit the Menu mode, press
LOCK button or MENU button to move to the next function.
4. When the Keypad tone is enabled, the tone icon appears on
the LCD display.
-12-
Stop Watch function
This function will enable a one hour timer function.
1. Press the MENU button eleven times, until the Stop Watch
icon and the 00:00 indication will blink on the LCD display.
2. Press the CH UP button to start counting and press the CH
DOWN button to stop the function. The radio can still operate
in this mode.
3. Press the CH UP button again to re-start.
4. To reset the timer press the CH DOWN button two times.
5. To exit to Stand-by mode press the LOCK button.
ADDITIONAL FUNCTIONS
Keypad Lock
To avoid entering unwanted command, press and hold the
LOCK button for about 2 seconds. The Lock icon will appear on
the LCD display. When the keypad is locked, the PTT, CALL
and Monitor buttons are enabled. To unlock the keypad press
and hold the LOCK button for about 2 seconds.
LCD Backlight
Shortly press the MONITOR button to backlight the LCD
display. Press this button again to turn OFF the LCD backlight.
Monitor Function
Press and hold the MONITOR button for about 4 seconds to
activate the Monitor function. Press MONITOR button once to
return.
If require to listen to weak signal with background noise
temporarily, press and hold MONITOR button for about 2
seconds. You will hear background noise and possible weak
signal from the unit. Release MONITOR button within 2
seconds to return.
Automatic Power Save
The radio has a Automatic Power Save circuit designed to
extend battery life. If it senses no signal within 10 seconds, it
automatically switches to the Power Save mode. The Power
Save icon will appear on the LCD display.
The radio can still receive transmission in this mode.
-13-