Advertisement
Page 9
Charging The Battery
The battery should be charged in a cool, dry place. Charging should be done with the fan off to avoid
the fan from running once the charger is removed. The built in safety circuit turns the fan off once the
charger is plugged into the PGF-V. The battery does not have to be fully discharged before recharging.
The battery will not develop a memory.
Approximate charge time is under 3 hours if the battery is completely discharged.
Prolonged Storage of the
PGF-V: To maintain maximum Battery Power and Longer
**
Service life of the PGF-V, the battery should be stored with a 50% charge. If the
charge level is unknown, then fully discharge the PGF-V and then add a charge for 1
½ hours. We suggest repeating this process every 3 months during non-usage
1. Plug the charger into an AC wall outlet. The LED on the front of the charger will illuminate green.
2. Plug the charger output into the charging receptacle on the fan.
3. The LED on the charger will switch to red indicating that the battery is charging.
4. Once the battery is fully charged the LED on the charger will turn green.
5. Unplug the charger from the fan and the wall socket. The safety circuits in the charger and the battery
will discontinue the charge once the battery is fully charged.
6. It is recommended to unplug the charger when not in use and not rely solely on safety circuits.
NOTE: Lithium-Ion batteries, while in use, will continue to provide full power with very little power
fade unlike typical batteries. When the battery is fully discharged, the battery safety circuits will immediately
cut power to the fan motor. The battery circuits will not allow the fan to run until the battery has been
recharged.
Note: It is recommended that the PGF-V be charged on a non-flammable surface.
supplied with an engineered charger and this is the ONLY charger that should be used
when charging the Lithium-Ion battery.
Charging Indicator Light
Red
when charging
Green
when fully charged
Copyright © 2015 CYNWARK Corporation
The PGF-V is
Additional chargers can be purchased thru our web site.
Make sure the fan is turned off before cleaning. Clean parts with a duster or damp cloth.
Use care around the motor housing to prevent liquid from coming in contact with motor.
Prior to resuming use make sure the PGF-V is dry and all moisture has been eliminated. Do
not immerse the PGF-V in any type of liquid or use abrasive cleaning solutions. When
storing the PGF-V in the off season, make sure it is in a dry environment and follow the
battery storage instructions on page 9.
Motor
**
Motor Speed
Approximate Charge Time
Approximate Run Time
Battery
Battery Charger Input
Battery Charger Maximum Output
Overall Height
Overall Weight
*
All specifications are based on the latest product information available at the time of
printing. We reserve the right to make changes at any time without notice. This device
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause
harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired
operation. Note: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of
the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This
equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may
cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the
equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.
Care & Cleaning
Specifications *
Brushless; ball bearing; 12V DC
5000 RPM under load
Less than 3 hours
(Battery fully discharged)
40 hrs on Low, 16 hrs on Medium, 4 hrs on High
(Battery fully charged)
11.1 V; 4.4 amp hour; lithium-ion (NMC)
100–240V; 50/60 Hz; 0.4A
12.6V DC; 2A
16 inches
2 lbs.
complies with part 15 of the FCC Rules.
www.PGFfan.com
888-938-6672
Page 10
Advertisement
