Advertisement
Page 3
personal go fan
Patented
The power switch is a round knob that is turned clockwise to power the fan on. The fan
speed is controlled by how far the knob is rotated so that the volume of air can be regulated.
To turn the fan off the knob needs to be rotated fully counter clockwise until a click is heard.
To adjust the position of the fan head; loosen the thumb screw, adjust the fan head position
and retighten the thumb screw. Do not over tighten the thumb screw.
NOTE: The Thumb Screw needs to be loosened before tilting the head. Failure to do so
could damage the adjusting mechanism or break the head of the PGF-V!
Copyright © 2015 CYNWARK Corporation
Motor Housing
Thumb Screw for Tilting Fan
Variable Speed On/Off Knob
Charging Port / Dust Cover
Screw on Cup Adapter
Operation
PGF-V Battery Installation
1. Using a Phillips screw driver remove the screw on the
battery door cover. Then remove cover exposing the
battery connection
2. Plug the wire leading from the PGF-V into the plug on
the battery wire. This battery connection is a one way
plug and can only be installed in a specific direction. The
red and black wires will line up with each other when
properly aligned.
3. Slide the battery into the holder. Then tuck the power
cord into the extra space around the battery.
4. Re-attach the battery door using the removed screw
and Phillips screw driver. Simply reverse steps 1 through
4 to remove the battery.
www.PGFfan.com
888-938-6672
Page 4
Advertisement
