Advertisement
Page 7
Boat Cup Holder Compatibility
We have done our very best to engineer a system of adapters that will fit into most
O.E.M. boat cup holders. However, there are so many different versions on the
market today it is impossible to insure they fit into every single one. Two cup adapters
and one polymer ring are supplied with the PGF-V that fit into most boat cup holders.
These adapters are shown below. Each adapter is numbered on the bottom for easy
identification.
1
#
Cup holders designed with LEDs, tangs, or smaller diameters will use adapter number
2 without the polymer boat ring as shown below.
Cup Adapter (2)
Copyright © 2015 CYNWARK Corporation
Polymer Boat
Ring
2
#
Tangs
Most cup holders found in boats will utilize the number 1 cup adapter with the boat
polymer ring added. This combination of adapter/polymer ring and examples of the
cup holders it fits are shown below.
Cup Adapter (1)
Polymer Boat Ring
Please Note: It's very important NOT to have the PGF-V installed in the cup holder
when under power at higher speeds and/or in rough water.
Is your PGF-V a little loose?
Every e ort has been made to supply cup adapters that t into the O.E.M. cup holders.
However, due to manufacturing tolerances the sizes can vary slightly. If needed, you can use
one of the following methods to create a more secure t:
1. Wrap duct tape around the cup adapter
to increase the width.
www.PGFfan.com
Page 8
2. Add a piece of velcro to the bottom of
the cup adapter and the cup holder.
888-938-6672
Advertisement
