Table of Contents
Advertisement
Electrical Requirements
Tumble dryers are supplied to operate at a
voltage of 220V-240V, 50 Hz single phase.
Check that the supply circuit is rated to at least
6A.
Electricity can be extremely dangerous.
This appliance must be earthed.
The socket outlet and the plug on the
appliance must be of the same type.
Do not use multiple adapters and/or
extension leads.
The plug should be accessible for
disconnection after the appliance has been
installed.
You may be charged for a service call if a
problem with your machine is caused by
incorrect installation.
If the supply cord is damaged, it must be
replaced by the manufacturer, its service agent
or smilarly qualifed persons to avoid a hazard.
Do not plug the machine in and switch it
on at the mains until the installation is
completed. For your safety, this dryer must be
correctly installed. If there is any doubt about
installation, call
Hoover Customer Care
advice.
Adjusting the Feet
Once the machine is in
place the feet should
be adjusted to ensure
that the machine is
level.
EN
6
INSTALLATION
VENTILATION
Adequate ventilation has to be provided to
avoid the back flow of gases into the room from
appliances burning other fuels, including open
fires.
● Exhaust air must not be discharged into a
flue which is used for exhausting fumes from
appliances burning gas or other fuels.
● Check regularly that the air flowing through
the dryer is not restricted.
● Check the
lint
necessary.
●The inlet and outlets should be kept free from
obstructions. To ensure adequate ventilation
the space between the bottom of the machine
and the floor must not be obstructed. There
should be a gap of at least 12mm between the
machine and any obstructions.
●
For appliances with ventilation openings in
the base, carpet must not obstruct the
openings.
● Prevent items from falling or collecting behind
the dryer as these may obstruct the air inlet and
outlet.
for
Important: During transport ensure that the
dryer is in an upright position, if it's necessary
you can only flip in the side shown;
Caution: If the machine is tilted other than to
the right side wait at least 4 hours before
swiching the machine on again so the
compressor oil can flow back to the
compressor. Failure to do so may damage the
compressor.
filter after use, and clean, if
Air Outlets in the Base
Hide quick links:
Advertisement
Table of Contents
