Silvercrest SBLV 20 A1 Operating Instructions And Safety Instructions page 7

■ If the power cable or connections are damaged, have them replaced by an
authorised specialist or the Customer Service department.
■ Protect the power cable from hot surfaces and sharp edges.
■ Ensure that the power cable is not taut or kinked.
■ Do not leave the power cable hanging over edges (tripping hazard).
■ Always place the device on a stable and level surface. It can be damaged if
dropped.
■ Do not expose the device to direct sunlight or high temperatures. Otherwise it
may overheat and be irreparably damaged.
■ Be sure to provide sufficient air circulation to avoid a heat build-up. Never cover
the device! Risk of fire!
■ Do not place the device near heat sources such as radiators or other heat-generating
appliances.
■ Never operate the device in the vicinity of naked flames (e.g. candles), and do
not place burning candles on or next to the device. This will help to prevent fires.
■ The device is not designed for use in rooms with high temperatures or humidity
(e.g. bathrooms) or where there is excessive dust.
■ Do not expose the device to water spray or dripping water, and do not place
liquid-filled objects such as vases or open drink containers on or near the device.
■ The speaker may warm up during charging. Place the speaker in a well-ventilated
location during the charging process and do not cover it.
■ DANGER! Never open the housing of the device. There are no user-serviceable
or replaceable components inside the device. Risk of electrical shock!
■ Do not make any unauthorised modifications or alterations to the device.
■ All repairs must be carried out by authorised specialist companies or by the
Customer Service department. Improper repairs may put the user at risk. It will
also invalidate any warranty claims.
■ Repairs to the device during the warranty period may only be carried out by
a customer service department authorised by the manufacturer. Otherwise, no
warranty claims will be held for any subsequent damages.
■ Defective components must always be replaced with original replacement parts.
Compliance with the safety requirements can only be guaranteed by using these
replacement parts.
■ Switch off the device immediately and pull the plug out of the power socket if
you smell fumes or notice any smoke. Have the device checked by a qualified
specialist before using it again.
■ The device consumes power in standby mode. To completely separate the device
from the power supply, the plug must be disconnected from the mains power
socket. The power socket must be easily accessible so that the mains adapter can
be easily disconnected in an emergency.
■ In the case of a malfunction occurring or a thunderstorm, disconnect the plug
from the mains power socket.
│ GB │ IE
■ 4 SBLV 20 A1