Rosen DS-GM0710 GM Series Installation Manual page 5

8 Locate the GPS Antenna and iPod Interface
You will need to mount the GPS Antenna on the exterior of the vehicle. Mount the optional iPod Interface Connector in
the vehicle. The following steps will help guide you through this process.
Note: Please route the GPS harness away from other power harnesses in the vehicle. This will help to ensure
optimum performance of the GPS system.
Note: Please locate the iPod interface module in an area which can be serviced in the future.
It is the installer's responsibility to ensure that the safety equipment in the vehicle is NOT
adversely affected by installation of this system. Ensure that the routing of the harnesses does
NOT obstruct airbags, SRS or other safety devices.
9 Connect and Install the Rosen Unit
You will need to make the Electrical Connections and install the Rosen Unit. The following steps will help guide you
through this process.
Note: Use caution when locating the wire harnesses to be sure they will not be damaged when the Rosen unit is
installed.
Step 1: Remove transport screws
Insure that the video disable connection is connected as intended and working as designed!!!
Be sure to fully engage all connectors and prevent them from causing vibrating noises
Rosen Entertainment Systems
Installation Guide
Installation Guide GM Series
Step 1: Mount the GPS antenna in
a location on the exterior of
the Vehicle
Step 2: Connect the GPS
Antenna, Steering Wheel
Control and Power
Connections
Step 2: Locate the iPod interface
connector for use by the
end-user
Step 3: Connect iPod and
optional Camera/Backing
System harnesses
Step 4: Prepare the Vehicle side
connection harnesses
Copyright 2009 all rights reserved
DP-GM0714 IG Rev D
Page 5