Rosen DS-GM0710 GM Series Installation Manual page 4

6 Remove the Interior Trim Components
You will need to remove the interior trim components prior to removing the factory radio. The following steps will help
guide you through this process.
Note: When removing the Interior Trim Components, use caution to prevent damage to the components. If you are
unsure about the removal process, consult the OEM Service Manual for additional instructions.
Note: Once the Interior Trim Components have been removed, be sure to inspect the clips for any damage.
Damaged part must be replaced before re-installation.
Step 1: Pull top of dash panel
towards you
Use Caution. See the OEM Service Manual for additional information on the removal process
7 Remove the Factory Radio
You will need to remove the Factory Radio and prepare the Rosen Multi-Media unit for installation. The following steps
will help guide you through this process.
Note: Be sure to inspect all brackets and clips to ensure they were not damaged during the removal process. If any
brackets or clips were damaged, replace them prior to installation of the Rosen unit.
Note: Standard Bose radio/connections shown below
Rosen Entertainment Systems
Installation Guide
Installation Guide GM Series
GMC Acadia Shown:
Step 2: Carefully remove lower
portion of dash
Step 1: Remove the OEM Radio
Step 3: Carefully remove dash
panel and set aside
(Note: No need to
disconnect climate
controls!)
Step 2: Unplug the Electrical
Connections
Step 4: Remove OEM Radio
Mounting Hardware
Copyright 2009 all rights reserved
DP-GM0714 IG Rev D
Page 4