Warranty And Repair; Maintenance; Line Fuse; Power Switch - Hameg HM8123 User Manual

3 ghz programmable counter
Hide thumbs Also See for HM8123:
Table of Contents

Advertisement

Available languages

Available languages

1.8

Warranty and Repair

HAMEG instruments are subjected to a strict quality control.
Prior to leaving the factory, each instrument is burnt-in for 10
hours. By intermittent operation during this period almost all
defects are detected. Following the burn-in, each instrument is
tested for function and quality, the specifications are checked
in all operating modes; the test gear is calibrated to national
standards.
The warranty standards applicable are those of the country
in which the instrument was sold. Reclamations should be
directed to the dealer.
Only valid in EU countries
In order to speed reclamations customers in EU countries may
also contact HAMEG directly. Also, after the warranty expired,
the HAMEG service will be at your disposal for any repairs.
Return material authorization (RMA):
Prior to returning an instrument to HAMEG ask for a RMA
number either by internet (http://www.hameg.com) or fax. If
you do not have an original shipping carton, you may obtain one
by calling the HAMEG service dept (+49 (0) 6182 800 500) or by
sending an email to service@hameg.com.
1.9

Maintenance

The instrument does not require any maintenance. Dirt may
be removed by a soft moist cloth, if necessary adding a mild
detergent. (Water and 1 %.) Grease may be removed with ben-
zine (petrol ether). Displays and windows may only be cleaned
with a moist cloth.
Do not use alcohol, solvents or paste. Under no
circumstances should any fluid be allowed to get
into the instrument. If other cleaning fluids are
used damage to the lacquered or plastic surfaces is
possible.

1.10 Line fuse

The instrument has 2 internal line fuses: T 0.8 A. In case of a
blown fuse the instrument has to be sent in for repair. A change
of the line fuse by the customer is not permitted.

1.11 Power switch

The instrument has a wide range power supply from 105 to
253 V, 50 or 60 Hz ±10 %. There is hence no line voltage selector.
I m p o r t a n t h i n t s
Subject to change without notice
21

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents