Table of Contents
Advertisement
2-6: LINK ASS'Y (Refer to Fig. 2-6)
1.
Set the Link Ass'y to the Eject position.
2.
Remove the (A) side of the Link Ass'y first, then remove
the (B) side.
Link Ass'y
(A)
Main Chassis
2-7: LOADING MOTOR ASS'Y (Refer to Fig. 2-7)
1.
Remove the Link Lever.
2.
Remove the Dumper Spring.
Remove the 2 screws 1.
3.
Unlock the support 2 and remove the Loading Motor
4.
Ass'y.
Unlock the 2 supports 3 and remove the Deck PCB
5.
(BOT).
Dumper Spring
Main Chassis
• Screw Torque: 5 ± 0.5kgf•cm
2-8: SENSOR COVER L3 (Refer to Fig. 2-8)
Unlock the support 1 and remove the Sensor Cover L3.
1.
Main Chassis
DISASSEMBLY INSTRUCTIONS
(B)
Link Ass'y
Main Chassis
Fig. 2-6
1
Loading Motor Ass'y
2
3
1
Deck PCB
(BOT)
Link Lever
Fig. 2-7
Sensor Cover L3
1
Fig. 2-8
2-9: TENSION ASS'Y (Refer to Fig. 2-9-A)
1.
Move the Inclined S Ass'y to the back side.
2.
Remove the Tension Spring.
Unlock the support 1 and remove the Tension Arm
3.
Ass'y.
4.
Remove the Tension Adjust.
Unlock the 2 supports 2 and remove the Tension Band
5.
Ass'y.
Unlock the support 3 and remove the Tension Holder.
6.
7.
Remove the SS Brake Spring.
8.
Remove the SS Arm Brake.
Tension Spring
SS Brake Spring
SS Arm Brake
NOTE
When you install the Tension Adjust, install as shown in
Fig. 2-9-B. (Refer to Fig. 2-9-B)
2-10: T BRAKE ASS'Y (Refer to Fig. 2-10)
1.
Remove the T Brake Spring.
2.
Remove the T Brake Ass'y.
T Brake Ass'y
B2-2
Tension Adjust
2
2
Tension Band Ass'y
Tension Arm Ass'y
1
Tension Holder
3
Inclined S Ass'y
Adjust the direction of the Marker to inside.
T Brake Spring
Fig. 2-9-A
Fig. 2-9-B
Fig. 2-10
Advertisement
Table of Contents
