Table of Contents
Advertisement
Operating Instructions
Busch-Watchdog
Pos: 23 /#Neustruktur#/Online-Dokumentation (+KNX)/Überschriften (--> Für alle Dokumente <--)/1. Ebene/G - L/Inbetriebnahme @ 11\mod_1279185496977_15.docx @ 83035 @ 2222222 @ 1
6
Commissioning
Pos: 24 /#Neustruktur#/Online-Dokumentation (+KNX)/Erstinbetriebnahme/Waechter/Hinweis - Inbetriebnahme - 6179 - IR Handsender KNX @ 30\mod_1348221983053_15.docx @ 237883 @ 2222222122 @ 1
Note
The IR remote control is coded and must be programmed to the Busch-Watchdog during
commissioning ("Programming the device").
This code (16 bit, corresponds to 65,536 possible variations) prevents movement detectors in the
surrounding area to be influenced unintentionally or deliberately.
Pos: 25 /#Neustruktur#/Online-Dokumentation (+KNX)/Inbetriebnahme/Waechter/Inbetriebnahme - 6179 IR-Handsender KNX @ 30\mod_1348222010319_15.docx @ 237897 @ 1211 @ 1
Removing the protective foil
Fig. 2:
Protective foil on the battery
1
Remove the protective foil from the battery before commissioning.
Programming the device
Fig. 3:
Programming the remote control
1. De-energize the Busch-Watchdog for at least 30 seconds.
2. Press any button on the remote control for at least 3 seconds within the period of 10 minutes after activating
the power on the Busch-Watchdog.
-
The remote control will then automatically connect itself to the Busch-Watchdog. The Busch-Watchdog
flashes if the reception is correct.
Repeat these steps to program a maximum of 14 additional remote controls.
Pos: 26 /#Neustruktur#/Online-Dokumentation (+KNX)/Steuermodule - Online-Dokumentation (--> Für alle Dokumente <--)/++++++++++++ Seitenumbruch ++++++++++++ @ 9\mod_1268898668093_0.docx @ 52149 @ 2222222211112221122 @ 1
Operating Instructions | 1473-1-8083
Commissioning
— 7 —
Advertisement
Table of Contents
