Firmware Version; Installation - Usl LSS-100P Installation And Operation Manual

Firmware Version

The LSS-100P is subject to constant improvement. Check
firmware. Note that the latest firmware can be used in both the LSS-100 and the LSS-100P. The LSS-100
does not have POE, the separate photopic sensor, contact closure script start, or the IR sensor.
Otherwise, the units will behave the same with the latest firmware. See the Firmware Update section for
instructions on updating the firmware.

Installation

It is a lot easier to do the initial testing of the LSS-100P on a table or the floor of the projection booth
instead of on top of a ladder.
1. Connect an Ethernet cable between the OUT connector of the supplied POE Power Injector and
the LSS-100P. Connect another Ethernet cable from the IN connector of the POE Power Injector
to a computer. Apply AC power to the POE Power Injector.
2. The green LED next to the Ethernet connector on the LSS-100P will light dimly for 30 seconds,
then light brightly. During this time, the LSS-100P is checking its backup copy of the system
firmware. The green LED is lit whenever the LSS-100P is powered unless the flash memory chip
is being accessed (such as during the firmware check, loading or saving of configuration
information, etc.).
3. Open a web browser and type http://169.254.1.6 in the address bar. (You can also use Ethernet
Device Discoverer to find the IP address of the LSS-100P.) On most laptops, this will bring up the
home page of the LSS-100P. If it does not, try changing the laptop's IP address to 169.254.1.123
with a subnet mask of 255.255.0.0. Most laptops have automatic crossover for Ethernet, but
some older ones do not. If the LSS-100P home page is still not visible, try using an Ethernet
crossover cable between the laptop and the POE injector. The LSS-100P home page is shown
below.
v160817
LSS−100P Installation & Operation Manual
Figure 3 - LSS-100P Graph
http://ftp.usl-inc.com/LSS-100P for the latest
8