Troubleshooting - Zanussi ZFC21400WA User Manual

the outer environment humidity and if the frozen
food is not wrapped properly.
The best time to defrost the freezer when it
contains no or only a little food.
1. Switch off the appliance.
2. Remove any stored food, wrap it in several
layers of newspaper and put it in a cool
place.
3. Leave the lid open , remove the plug from
the defrost water drain and collect all
defrost water on a tray. Use a scraper to
remove ice quickly.
4. When defrosting is completed, dry the
interior thoroughly and refit the plug.
5. Switch on the appliance.
6. Set the temperature regulator to obtain the
maximum coldness and run the appliance
for two or three hours using this setting.

Troubleshooting

WARNING!
Refer to Safety chapters.
What to do if...
Problem
The appliance does not operate.
The appliance is noisy.
Audible or visual alarm is on.
Power indicator light is flashing.
The lid doesn't close completely.
8
7. Reload the previously removed food into the
Periods of non-operation
When the appliance is not in use for long
periods, take the following precautions:
1. Switch off the appliance and disconnect the
2. Remove all food
3. Defrost and clean the appliance and all
4. Leave the lid open to prevent unpleasant
Possible cause
The appliance is switched off.
The mains plug is not connected
to the mains socket correctly.
There is no voltage in the mains
socket.
The appliance is not supported
properly.
The cabinet has been recently
switched on or the temperature
in the appliance is too high.
An error has occurred in measur-
ing the temperature or the appli-
ance is not working properly.
Food packages are blocking the
lid.
There is excessive frost.
compartment.
appliance from electricity supply.
accessories.
smells.
If the cabinet will be kept on, ask
somebody to check it once in a
while to prevent the food inside from
spoiling in case of a power failure.
Switch on the appliance.
Connect the mains plug to the
mains socket correctly.
Connect to a different electrical
mains socket. Contact a qualified
electrician.
Check if the appliance stands
stable.
Refer to "High Temperature
Alarm" and if the problem still oc-
curs contact the nearest Author-
ized Service Centre.
Contact the nearest Authorized
Service Centre.
Arrange the packages in the right
way, see the sticker in the appli-
ance.
Eliminate excess frost.
Solution
www.zanussi.com