AEG FT 4925 Instruction Manual page 84

English
84
Taking Temperature in Ear Temperature Mode
1) When the system is in the state of time/environmental tem-
perature display, press the button of scan, and the last tempera-
ture measurement will be displayed; then after "Beep-Beep",
the system enters into the mode of measurement.
2) Remove the probe cap, and the thermometer enters into
the ear measuring mode (Refer to the Picture 7.1).
3) Carefully pull back the ear to stretch the auditory canal.
When measuring ear temperature, insert the probe into
the ear first (refer to the Picture 7.2), then press the but-
ton of scan. One second later you will hear "Beep", and
you can remove the thermometer. The measurement is
completed.
4) When the measured temperature exceeds 38.0°C the thermometer will
send out "Beep-Beep-Beep" a long one and two short ones, and the
display will show the icon of fever (Refer to the Picture 7.3).
Notes:
• Keep the probe surface clean, otherwise the measurement can't be
accurate.
• Clean the probe with clean cloth or paper moistened with water or
alcohol, and conduct measurement after the water on the surface of
the probe all evaporates.
(Picture 7.1)
(Picture 7.2)
(Picture 7.3)