Adding Washer Solvent - Alfa Romeo 4C 2017 Owner's Manual

If there is not a jet of fluid, first check that there is fluid
in the washer reservoir. Refer to "Adding Washer
Solvent" in this section for further information.
Then check that the nozzle holes are not clogged; use a
suitable tool such as a needle to unblock them if
necessary.

Adding Washer Solvent

1 — Brake Fluid Access Panel
2 — Washer Solvent Access Panel
To check the windshield washer solvent level, proceed
as follows:
MAINTAINING YOUR VEHICLE 221
1. To avoid any interference during the procedure, lift
the windshield wiper blade.
2. Loosen the four screws using the supplied screw-
driver. Remove the washer solvent protection panel.
1 — Screw Locations
3. Release the plug from the opening.
4. Leaving the plug close to the opening, put a finger on
the central hole in the plug and remove it: the level
can be seen on the control pipe due to capillarity.
7