Samsung SV-DVD440P Service Manual page 2

◆ MODE SWITCH (PROGRAM SWITCH) ASSEMBLY POINT
1) When installing the ass'y deck on the Main PCB, be sure to align the assembly point of mode switch.
◆ HOW TO EJECT THE CASSETTE TAPE
(If the tape is stuck in the unit)
1) Turn the Gear Worm Πclockwise in the direction of arrow with a screwdriver. (See Fig. 2)
(Other method ; Remove the screw of Motor Load Ass'y, Separate the Motor Load Ass'y)
2) When Slider S, T approachs the unloading position, rotate holder Clutch counterclockwise after inserting screwdriver in the
frame's bottom hole in order to wind the unwound tape. (Refer to Fig. 3)
(If you rotate Gear Worm Πcontinuously when tape is unwinding, you may cause tape contamination by grease and
tape damage. Be sure to wind the unwound tape with the unit in the horizontall position.)
3) Rotate Gear Worm Πclockwise using a screwdriver until the mecha is in the eject state. Remove the tape. (Refer to Fig. 2)
Fig. 2
IMPORTANT SERVICE GUIDE
VCR MAIN PCB
ΠGEAR WORM
Fig. 1
FRAME
ASSEMBLY POINT
Fig. 3