Pablo circa Assembly And Installation Instructions Manual page 19

CIRCA PENDANT
ASSEMBLY INSTRUCTIONS
CIRCA PENDANT
IMPORTANT: WE RECOMMEND FIXTURE BE INSTALLED BY AN ELECTRICIAN
1
ROUTE BUILDING WIRING THROUGH MOUNTING
PLATE, THEN ATTACH PLATE TO JUNCTION BOX
2
CUT FIXTURE CORD TO DESIRED LENGTH, ADDING
AN ADDITIONAL 3 INCHES (7.6 CM) FOR WIRING
BEFORE CUTTING, WRAP CORD
WITH ELECTRICAL TAPE TO PREVENT
THE FABRIC SLEEVE FROM FRAYING
NOTE: IF JUNCTION BOX IS NOT LOCATED IN THE DESIRED
POSITION FOR CIRCA PENDANT, SEE BACK PAGE FOR SWAG
MOUNT INSTALLATION
pg. 19
3
ROUTE FIXTURE AND BUILDING CORDS AS SHOWN,
THEN PULL CIRCA PENDANT TO DESIRED HEIGHT
AND SET STRAIN RELIEF
ADD 3
INCHES
(7.6 CM)
FOR
WIRING
USE FLAT HEAD
SCREWDRIVER
TO SET STRAIN
RELIEF