Pablo circa Assembly And Installation Instructions Manual page 15

CIRCA WALL
ASSEMBLY INSTRUCTIONS
PARTS LIST
A
B
1
USE THE MOUNTING PLATE AS A TEMPLATE FOR
MARKING THE LOCATION OF THE WALL ANCHORS
PLACE THE MOUNTING PLATE
IN THE DESIRED LOCATION.
MAKE SURE TOP IS LEVEL
MARK THE CENTER OF ALL
FOUR HOLES AS SHOWN
3
SCREW THE MOUNTING PLATE TO THE ANCHORS
WITH THE SCREWS PROVIDED
pg. 15
CIRCA WALL
D
C
NOTE ORIENTATION
OF MOUNTING PLATE
G
F
E
2
REMOVE THE PLATE FROM THE WALL AND INSTALL
ALL FOUR WALL ANCHORS
TAP THE UNTHREADED TIP
OF THE ANCHOR INTO THE
WALL
USE A PHILLIPS SCREWDRIVER
TO COMPLETE THE ANCHOR
INSTALLATION
THIS SURFACE SHOULD
BE FLUSH WITH THE WALL
4
SCREW LAMP ARM TO THE MOUNTING PLACE WITH
THE FOUR MACHINE SCREWS PROVIDED
ROUTE CORD AS SHOWN
A. LAMP HEAD
B. FACEPLATE
C. 4x MACHINE SCREWS
D. LAMP ARM
E. 4x SCREWS
F. MOUNTING PLATE
G. 4x WALL ANCHORS