Advertisement
Charging
Charge the Trimmer fully before you start using it
for the first time or after a long period of disuse.
This Trimmer will not operate corded directly
from the electric outlet.
To Charge / Recharge
◗
(Re)charging requires 10 hours.
◗
Use only the cord provided.
◗
Battery performance is best if you recharge
only when the battery is (almost) completely
empty.
◗
Charging or recharging at temperatures below
40°F or higher than 95°F adversely affects
lifetime of battery.
◗
Continuously recharging Trimmer will reduce
life of battery.
1
Be certain Trimmer is OFF (fig. 1).
2
Connect cord to Trimmer. Plug into any 120V
AC outlet. Use only the cord provided (fig.2).
◗
An adaptor plug may be necessary for cord
usage in some foreign countries. Use an
attachment plug adaptor of the proper
configuration for power outlet.
Do not charge Trimmer for more than 24 hours.
3
Green Charging Indicator Light on the
adaptor will go on to indicate the Trimmer is
charging (fig. 3).
It will take approximately 10 hours to fully charge
the battery.
4
Disconnect the cord and unplug from
electrical outlet.
Optimize The Working Life
Of The Battery
◗
After Trimmer has been charged for the first
time, do not recharge Trimmer between
trimming sessions. Continue using it until the
battery is completely empty.
◗
Discharge the battery completely twice a year
by letting the motor run until it stops.
◗
Do not charge for more than 24 hours.
◗
Do not keep cord permanently plugged in.
◗
If Trimmer hasn't been used for a long period of
time,Trimmer must be recharged for 10 full
hours.
Cordless Trimming
1
Charge according to directions. Unplug
Trimmer from outlet and remove cord.
2
Slide ON/OFF switch ON to begin trimming.
3
If the battery is empty and you want to trim
your beard, charge the Trimmer for at least
90 minutes and you will have enough power
for one use (10 minutes).
Trimming
◗
Use this Trimmer for its intended household
use as described in this manual.
◗
Always comb the beard and/or moustache
with a fine comb before you start trimming.
◗
If you are trimming for the first time, be
careful. Do not move the Trimmer too fast.
Make smooth and gentle movements.
Trimming with AccuControl
Guide Comb Attachment
◗
Guide Comb Attachment must be on Trimmer
in order to use the Zoom Lock.
1
Turn the Zoom Lock to the desired trimming
length setting (see table).The setting will
appear in the window below the Zoom Lock
(fig.4).
◗
If you are trimming for the first time,start by
using the maximum trimming length setting (#9)
to prevent accidentally trimming hairs too short.
As you become familiar with the settings, adjust
Zoom Lock to desired trimming length. Zoom
Lock will "click" into position at each setting.
2
Switch the Trimmer ON.
3
To trim in the most effective way, move the
Trimmer against the direction of hair growth.
Make sure the surface of the Guide Comb
always stays in contact with the skin (fig. 5).
NOTE: Since all hairs do not grow in the
same direction, you may want to try different
trimming positions (i.e., upwards,
downwards, or across). Practice is best for
optimum results.
4
If cut hairs have accumulated in the
Guide Comb, turn Trimmer off, remove
the Comb Attachment and blow and/or
shake the hair out of the comb.The
selected trimming length setting will not
change when you do this (fig. 6).
Advertisement
