Fuse Replacement - Martin RUSH Scanner 1 LED User Manual

To clean the fixture:
1. Disconnect the fixture from power and allow it to cool for at least 10
minutes.
2. Vacuum or gently blow away dust and loose particles from the outside of
the fixture and the air vents with low-pressure compressed air.
3. Clean the mirror and LED lenses by wiping gently with a soft, clean lint-
free cloth moistened with a weak detergent solution. Do not rub the
surface hard: lift particles off with a soft repeated press. Dry with a soft,
clean, lint-free cloth or low-pressure compressed air. Remove stuck
particles with an unscented tissue or cotton swab moistened with glass
cleaner or distilled water.
4. Check that the fixture is dry before reapplying power.

Fuse replacement

If you need to replace a fuse:
1. Disconnect the fixture from power and allow it to cool for at least 10
minutes.
2. Unscrew the cap of the fuse holder (shown on page 10) and remove the
fuse. Replace with a fuse of the same size and rating only.
3. Reinstall the fuseholder cap before reapplying power.
RUSH™ Scanner 1 LED User Manual 29