TECHNICAL SPECIFICATIONS SPECIFICHE TECNICHE MODEL WD10P WD12P WD15P System type 2-way coaxial vented 2-way coaxial vented 2-way coaxial vented High Frequency Device 1” neo compression driver with 1"VC 1” compression driver with 1.35"VC 1” compression driver with 1.35"VC Low Frequency Device 10”...
HPC610BK HPC610FRS this is a short extraction of the wide assortment of cables available from questo è un breve estratto del vasto assortimento di cavi disponibile da PROEL, PROEL, please visit our website at www.proel.com vi preghiamo di visitare il nostro sito web all'indirizzo www.proel.com...
Page 5
CONFIGURATIONS (FIG.3) CONFIGURAZIONI (FIG.3) WD passive BASIC 2-channel system LEFT RIGHT single speaker single speaker 8 ohm load 8 ohm load WD passive DOUBLE PARALLEL 2-channel system LEFT RIGHT paralled speakers paralled speakers 4 ohm load 4 ohm load...
• Sometimes it helps to plug all audio equipment into the same AC circuit so they share a common ground. CE CONFORMITY • Proel products comply with directive 2004/108/EC (EMC), as stated in EN 55103-1 and EN 55103-2 standards and with directive 2006/95/CE (LVD), as stated in EN 60065 standard.
This warranty does not extend to damage resulting from improper installation, misuse, neglect or abuse. Proel S.p.A. will verify damage on returned units, and when the unit has been properly used and warranty is still valid, then the unit will be replaced or repaired. Proel S.p.A. is not responsible for any "direct damage"...
• To obtain the best result using 2 (as single 8 ohm speaker for each channel) to 4 (as parallel 4 ohm speaker for each channel) WD15P connected in stereo, we suggest the use of PROEL HPX1200 or HPX2400 amplifier.
AC, in modo che tutti gli apparati condividano la stessa presa di terra. CONFORMITÀ CE • I Prodotti Proel sono conformi alla direttiva 2004/108/EC (EMC), secondo gli standard EN 55103-1 ed EN 55103-2 ed alla direttiva 2006/95/CE (LVD), secondo lo standard EN 60065.
• Per ottenere il miglior risultato usando 2 (come singolo altoparlante a 8 ohm per canale) o 4 (come doppio altoparlante a 4 ohm per canale) WD15P collegate stereo, si suggerisce l'uso dell'amplificatore PROEL HPX1200 o HPX2400. IMPORTANTE: il clip avviene qualora il segnale all'uscita di un qualsiasi dispositivo nel sistema (non solo l'amplificatore) raggiunge il suo massimo livello.
Need help?
Do you have a question about the WD10P and is the answer not in the manual?
Questions and answers