Preparation For Charging The Hybrid Battery - Volvo XC 60 TWIN ENGINE Owner's Manual

Table of Contents

Advertisement

STARTING AND DRIVING
Preparation for charging the hybrid
battery
Before starting to charge the car's hybrid bat-
tery, a number of preparations need to be made.
WARNING
The hybrid battery must only be charged
at maximum permitted charging current
or lower in accordance with applicable
local and national recommendations for
hybrid charging from 230 VAC sockets/
plugs.
Charging the hybrid battery must only
take place from an approved grounded
14
230 VAC socket
or from a charging
station with a loose charging cable (Mode
3) supplied by Volvo.
The control unit's ground fault breaker
protects the car, but there may still be a
risk of overloading the 230 VAC mains
power circuit.
Avoid visible worn or damaged mains
sockets since they may lead to fire dam-
age and/or personal injury if used.
Never use an extension cable.
Never use an adapter.
14
Or equivalent sockets with a different voltage, depending on market.
Maximum charging current may vary depending on market.
15
460
WARNING
Replacing the hybrid battery must only be per-
formed by a workshop - an authorised Volvo
workshop is recommended.
Before charging
IMPORTANT
The charging cable and its associated
parts should not be swamped or
immersed in water.
Avoid exposing the control unit and its
plug to direct sunlight. In such cases, the
overheating protection in the plug is at
risk of reducing or interrupting the charg-
ing of the hybrid battery.
IMPORTANT
Check that the 230 VAC socket has ade-
quate power capacity for charging elec-
tric vehicles - in the event of uncertainty,
the socket must be checked by a quali-
fied professional.
If the socket has unknown power
capacity - use the lowest level on the
control unit.
On the charging cable's control unit, set the
required charging current 6-16 A
the lowest possible charging current is preset.
Opening/closing the hatch for the
charging input socket
First unlock the car with the remote control key.
Press in the rear section of the cover and
release.
Open the cover.
Close the cover for the charging input socket in
reverse order.
15
. On delivery,

Advertisement

Table of Contents
loading

Table of Contents