Diagrams - Sony NW-A605 Service Manual

NW-A605/A607/A608
Note on Schematic Diagram:
• All capacitors are in µF unless otherwise noted. (p: pF) 50 WV
or less are not indicated except for electrolytics and tantalums.
• All resistors are in Ω and
1
/ W or less unless otherwise speci-
4
fied.
• % : indicates tolerance.
• C : panel designation.
• : B+ Line.
• Voltages and waveforms are dc with respect to ground under
no-signal (detuned) conditions.
no mark : PLAY
: Impossible to measure
*
• Voltages are taken with a VOM (Input impedance 10 MΩ).
Voltage variations may be noted due to normal production toler-
ances.
• Waveforms are taken with a oscilloscope.
Voltage variations may be noted due to normal production toler-
ances.
• Circled numbers refer to waveforms.
• Signal path.
a
: DIGITAL OUT
k
: DIGITAL IN
d
: TUNER
F
: AUDIO
• Waveforms
– MAIN Board –
1
IC400 <zcm (XTAL)
44.3 ns
500 mV/DIV, 20 ns/DIV
2
IC401 8 (OSCOUT)
30.4 µ s
500 mV/DIV, 20 µ s/DIV
12
SECTION 4

DIAGRAMS

3
IC601 ef (XOUT) WMA PLAY
2.4 Vp-p
500 mV/DIV, 20 ns/DIV
4
IC901 0 (XIN) USB Connect
1.2 Vp-p
500 mV/DIV, 20 ns/DIV
Note on Printed Wiring Board
• X : parts extracted from the component side.
• Y : parts extracted from the conductor side.
• : Pattern from the side which enables seeing.
Caution:
Pattern face side: Parts on the pattern face side seen from
(Side A) the pattern face are indicated.
Parts face side: Parts on the parts face side seen from
(Side B) the parts face are indicated.
• MAIN board is multi-layer printed board.
However, the patterns of intermediate-layer have not been in-
cluded in the diagram.
* Replacement of IC400, IC450, IC901 on MAIN board
requires a special tool.
• Lead Layouts
Lead layout of conventional IC
1.3 Vp-p
59 ns
2.1 Vp-p
41.6 ns
surface
CSP (Chip Size Package)