Oster BLSTCP User Manual page 4

u
sIng
Clean blender according to the instructions in the
"Cleaning and Storing Your Blender" section.
Jar Assembly:
– T urn jar upside down so the small opening is at
the top. (Figure 1)
– P lace sealing ring over jar opening. (Figure 2)
– P lace blade into jar. (Figure 3)
– S nap threaded bottom disc and collar together.
Place collar over blade and jar. (Note: If there
are slots on top of collar, line them up with
notches on jar.) Place the collar on jar and turn
the threaded bottom disc clockwise to tighten.
(Figure 4)
– Place jar assembly onto base. (Figure 5)
– Place ingredients into jar.
– Place lid with feeder cap on jar.
– P lug the power cord into a 120 Volt AC
electrical outlet.
P b m
ush utton odels
Slide switch to HIGH or LOW (If your model does
not have a slide switch, push HIGH or LOW button.)
Push desired speed and blend ingredients to desired
consistency.
Push OFF to stop the blender and turn blender off. To
use PULSE, select HIGH or LOW. Push PULSE and
hold down for desired length of time.Release PULSE
and allow blade to stop. Repeat cycle as desired.
d m w t
Ial odels Ithout
Turn dial to desired food/drink selection. Press ON
and blend ingredients to desired consistency. Press
OFF to stop the motor and turn blender off. Note:
Food/drink selection can be changed during blending
by turning the dial to the desired selection.
To use PULSE, turn dial to desired food/drink
selection. Press PULSE and hold down for desired
length of time. Release and allow blade to stop.
Repeat cycle as desired.
6800-6839_6850-6889_BLSTCP_BLSTCC_14EFSM1.indd 24-25
Y b
our lender
F
IGURE
F 1
IGURE
F
IGURE
F
IGURE
F
IGURE
F
IGURE
Imer
F
IGURE
F
IGURE
F
IGURE
English 6
d m
Ial odels
PRESS POWER TO TURN THE BLENDER ON.
The blender is set to the food/drink selection identified
by a blinking indicator light. Turn dial to change the
food/drink selection.
Press START and blend ingredients to desired
consistency. Press STOP to stop the motor. (Pressing
POWER stops the motor and turns the blender off.)
NOTE: Food/drink selection can be changed during
blending by turning the dial to the desired selection.
1 F
NOTE: This blender is programmed to turn the power
off automatically if not used for a period of several
F
minutes.
1 F
To use PULSE, turn dial to desired food/drink
selection. Press PULSE and hold down for desired
length of time. Release and allow blade to stop.
Repeat cycle as desired.
To use Auto Blend™ Timer, press BLEND TIME
until desired length of blending time (15, 30, 45, 60
seconds) is illuminated.
Turn dial to desired food/drink selection. Press
START. Blender will automatically stop when selected
time has elapsed. To stop blender before elapsed
time, press STOP. To use blender without timer, press
BLEND TIME until no lights are illuminated.
2 F
b t
lendIng
2 F
• P ut liquids in the jar first, unless a recipe says
otherwise.
2 F
• C rushing ice: Crush 6 ice cubes or approximately
2 cups of ice at a time.
• T his blender has been designed to gently process
foods when operating at low speeds. If blades do
not rotate during operation, simply choose a higher
speed.
• D o not remove the lid while in use. Remove feeder
cap to add smaller ingredients. (Figure 7)
• C ut all firm fruits and vegetables, cooked meats,
fish and seafood into pieces no larger than 1/2 inch
(1.8 cm) to 1 inch (2.5 cm). Cut all kinds of cheeses
F
3
into pieces no larger than 1/2 inch (1.8 cm).
• T his blender will not mash potatoes, whip egg whites or substitute dairy
3 F
toppings, mix stiff dough or grind raw meat.
F
3
w t
Ith Imer
F 1
IGURE
4
IGURE
F 1
IGURE
4
IGURE
F 1
IGURE
4
IGURE
F 2
IGURE
5
IGURE
IPs
F 2
IGURE
5
IGURE
F 2
IGURE
5
IGURE
F 3
IGURE
6
IGURE
F 3
IGURE
6
IGURE
F 3
IGURE
6
IGURE
English 7
F 4
IGURE
F 4
IGURE
F 4
IGURE
F 5
IGURE
F 5
IGURE
F 5
IGURE
F 6
IGURE
F 6
IGURE
F 6
IGURE
12/24/14 9:37 AM