Dear Client, Our compliments for having chosen a top-quality Immergas product, able to assure well-being and safety for a long period of time. As an Immergas customer you can also count on a quali ed a er-sales service, prepared and updated to guarantee constant e ciency of your storage tank unit.
Only professionally enabled heating/plumbing In the event of malfunctions, faults or incorrect Important: these units are used to store water at technicians are authorised to install Immergas operation, turn the appliance o immediately a temperature below boiling point at atmospheric appliances.
(Fig. 1-3). For correct connection of 1.5 SYSTEM FILLING. the storage tank unit to Immergas boilers, see the Once the storage tank has been connected, ll Storage tank connection to the boiler. boiler instruction book.
70°C). is prepared for application of the pump kit. wax element, sensitive to the temperature, Immergas supplies a series of fittings and Any release of the three-way mixing valve. If automatically controls the temperature of the...
- all presence of water in the system has been envisioned on the UB INOX Solar 200-2 storage return valve (8 Fig. 1-6). is method allows eliminated, which could cause damage to the to expel the air from the circuit.
7 Close the lling valve and switch the lling 10 Switch the solar pump on at a maximum Make sure that all air bubbles have been com- pump o , open the adjustment screw of the speed and make it function for at least 15 pletely eliminated.
Page 8
List and description of parameters available. e board has 34 parameters. e parameters that go from 1 to 11 is simple information and cannot be modi ed. N° Description of the Parameter Values Field Default Parameter So ware Version 1÷99 Current temperature S1: NTC sensor (°C) 0÷120 Current temperature S2: NTC sensor (°C)
Page 9
• Use and functioning. - Priority solar function. The function is - Solar pump functioning. active when: - Start-up display. The pump activates and deactivates DHW inhibition probe T (PAR 31 - PAR 33) automatically when it is set in On/O mode. Every time power is supplied to the appliance, <...
INSTRUCTIONS FOR USE AND MAINTENANCE. 2.1 CLEANING AND MAINTENANCE. e appliance must be serviced every year. is ensures that the optimal safety, performance and operation characteristics of the appliance remain unchanged through time. 2.2 EMPTYING THE STORAGE TANK UNIT. To drain the storage tank, use the special valve in the lower part of the storage tank (Fig.
CONTROL AND MAINTENANCE 3.1 HYDRAULIC DIAGRAM. Key: 16 - Solar expansion vessel 1 - Storage tank unit draining valve 17 - Solar pump 2 - 8 bar safety valve 18 - Flow meter 3 - Magnesium anode 19 - Domestic hot water probe 4 - Domestic hot water expansion vessel 20 - DHW inlet probe 5 - Stainless steel coil for storage tank...
3.2 WIRING DIAGRAM. Brown Blue Yellow Blue 230 Vac 50 Hz Brown Yellow power supply Blue Green Brown Green Black White White Black Black Grey Black White Black White Green Orange BOILER CLAMPS 36 AND 37 Purple Blue Brown Brown INTEGRATION Blue Key:...
3.4 CASING REMOVAL. To facilitate storage tank maintenance, the casing can be completely removed as follows: N.B.: the casing removal procedure is the same for all storage tank unit models. - remove the lid (1) pulling it upwards; - loosen the screws (2) and pull the front panel outwards (3);...
Page 16
Immergas S.p.A. 42041 Brescello (RE) - Italy T. +39.0522.689011 F. +39.0522.680617 immergas.com...