Control Panel Instruction - Clearlight CE-2 Assembly Instructions Manual

1) Press "POWER"to turn your sauna on or off.
2) "TIME"refers to the amount of time for your sauna session. Once your sauna is powered
on, the default session time of 45 minutes will be displayed. Press " UP Arrow or "DOWN
Arrow" to adjust and set the maximum time for your sauna session; pressing once will
increase or decrease the time in 5 minute increments. The maximum operating time is 60
minutes. After the session time is set, the number will flash for about three seconds.
After the set "Time" stops flashing , the remaining time, in minutes, will be displayed.
3) "TEMP"shows the current temperature inside the sauna and allows you to set a maximum
temperature for your session. "Celcius/Fahrenheit" allows you to switch the displayed
temperature in either Celcius or Fahrenheit.
Press"UP Arrow"or"DOWN Arrow"below the temperature display to adjust and set the
temperature in the sauna room; pressing once will increase in one degree increments. The
maximum set temperature is 150°F / 65°C.
After you set the sauna temperature, the set temperature displayed will flash for about 5
seconds. After the numbers of the set temperature stop flashing, the number indicated will
show actual air temperature inside sauna room.
4) Press "Outside" to turn on or off the outside lights.
5) Press "Inside" to turn on or off the inside lights and press "Outside" to turn on or off the
outside lights.
Note:
The remote controller is operates the same as above.

CONTROL PANEL INSTRUCTION

9